Actron KAL8300 Bedienungsanleitung PDF herunterladen (Seite 16)

Vehicle Battery

1. Turn ignition key OFF.

2. If battery is being charged, then stop, turn charger OFF

and disconnect clamps or leads. The battery cannot be

accurately tested while connected to a charger.

3. The connections must be clean and must make

good contact to achieve correct test results.

4. On side-post type batteries, install terminal stud

adapters. These are not included, but are available at most automotive parts

stores.

Faulty Connection

1. Once tester is ready, if a connection looses continuity, then a message will

identify the clamp that has a bad connection: Red (rd) or Black(bL).

2. If the connections are good and the tester is not ON, then the battery voltage

is below 7V.

 Disconnect tester and charge battery. Follow

battery charger manufacturers instructions for

proper battery charging procedures.

WARNING!

Charging a battery with a bad cell may cause severe personal injury and

damage to vehicle and/or equipment.

 Disconnect charger and reconnect the tester. If the LED display does not

illuminate, then the battery is not accepting a charge and should be replaced.

Ignition OFF

OK To Test Series Connected Batteries

TO VEHICLE

POWER

TO VEHICLE

GROUND

POS

NEG

POS

NEG

POS

NEG

TO VEHICLE

GROUND

TO VEHICLE

POWER

Parallel ConnectionMUST Be Disconnected

POS

NEG

POS

NEG

POS

NEG

Disconnect Parallel Connections

EN-4

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Actron KAL8300 Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messgeräte Actron KAL8300